15% off all kits!  Only for a limited time  ·  Visit the store →
A Builder’s Favorite for Over 25 Years
General Guitar Gadgets
Fine stompbox kits, projects & PCBs
The Projects/Modulation/Echo/Univox™ Uni-Vibe™

Project · Modulation/Echo

Univox™ Uni-Vibe™

This is a Univibe™ replica project. This project is from the GEOFEX site, with a link to a schematic file there.

The story

About the circuit

The Uni-Vibe™ was designed in Japan by Fumio Mieda and built by Shin-ei™ in the late 1960s, then sold by Univox™. It was meant to imitate a rotating Leslie speaker. Instead of an LFO driving transistors, a small incandescent lamp pulses inside a light-proof box, and four photocells around it shift the phase of the signal, each a little differently. The result has a throb and a sweep no ordinary phaser has, and it is the sound of Jimi Hendrix at Woodstock and on "Machine Gun," and of Robin Trower's Bridge of Sighs. It also came with a foot controller for the speed.

This project at GGG

Our Uni-Vibe™ project comes from R.G. Keen's GEOFEX work, with a link to his schematic and a sound sample from Claus Misfeldt. It is one of the more involved builds on the site, which is why we sell it as a ready-to-solder circuit board rather than a complete kit; the board takes the lamp-and-photocell arrangement the sound depends on. The project file and the clear PCB file are below.

More about this project

Notes, sounds and related links

Here's a short sound sample of this Univibe™ replica from Claus Misfeldt.

Ready to build? We have the kit.

Would you like a Ready to Solder Circuit Board for this project?